Receive E-Mail?

[fisamo]

Tim,

Just a thought. The IVR command ***999 reboots the ATA. For some folks it may be easier than unplugging it.

Thanks again,

One other point--this code only works for the Grandstream ATA. I don't know if the reboot command on the PAP2 is disabled by provisioning (or password protected--not sure why it would be), but if it's not restricted, the reboot sequence on the PAP2 is to dial **** (to access the IVR menu) and then type in "Reboot" (732668#). That works well if you don't want to mess with wires.

[abward]

Just tried that on my PAP2T and it rebooted!

Would this also work if I was dialing in remotely to home? If not, how would I reboot a PAP2T remotely?

[fisamo]

Just tried that on my PAP2T and it rebooted!

Would this also work if I was dialing in remotely to home? If not, how would I reboot a PAP2T remotely?

That will not work for dialing in from remote. There is a URL you can access to reboot the system that is admin-pw protected; I don't know if there's one that is NOT admin-locked.