Quote Originally Posted by voip123 View Post
OK. I can see your setting as below:
#1 comcast modem (correct?). The default gateway on the device is 172.20.0.1. Now leave the DHCP enable on this device.

#2 your RT. When you connect the RT to the #1 in any port. But you must connect the other end on RT into the <B>Internet</B> port.

#3 A XP machine that connects to the RT.

If you run the ipconfig /all on the XP, you should get something like this:
IP: 172.20.0.1XX
Subnet: 255.255.255.0
Gateway: 192.168.15.1
DNS: 192.168.15.1 <- I am not sure about this one. Did you assign this?

Now open a browser,and type: http://172.20.0.1XX, the one you got from the command ipconfig /all. You might try: http://172.20.0.1XX:8080 or http://172.20.0.1XX:9999, it depends on the port VOIPo sets for you.

See if you can access.

I've been following this thread and you have me confused. If I am missing something I apologize for "butting in."

Why would he be getting a 172.xx address off the LAN side of his WRT router to his (XP) computer. Unless he made changes the "normal" IP generated on the lan side would be in the private 192.168.x.xxx range. I've never seen a router (out of the box) generate a public IP on the LAN.

When I run IPCONFIG/ALL I get this (this is Win7):

  • Connection-specific DNS Suffix . :
    Description . . . . . . . . . . . : Realtek PCIe GBE Family Controller
    Physical Address. . . . . . . . . : 00-xx-xx-xx-5F-9F
    DHCP Enabled. . . . . . . . . . . : Yes
    Autoconfiguration Enabled . . . . : Yes
    IPv4 Address. . . . . . . . . . . : 192.168.1.20
    Subnet Mask . . . . . . . . . . . : 255.255.255.0
    Default Gateway . . . . . . . . . : 192.168.1.1
My Voipo device is getting 192.168.1.5 and to access it I use http://192.168.1.5
Again, if I am misunderstanding something I apologize.