Glad you're up and running. I would have posted replies to both of your messages, but you had already figured out work-arounds before I read them. (I suppose that's a good thing.. ) Another thing you could do with your system is to prepend a specific * code for trunk select. You can also make it a # code--if the # is explicitly referenced in your dial plan or your "Feature dial services codes" (under the Regional tab), the PAP2 will not treat the # key as a sequence termination signal (e.g. send dialed digits now). Using the Feature Dial Services Codes field allows you to indicate the vertical service codes you use--enter each one in there separated by a pipe, and your PAP2 will give you the 'prompt tone' once it recognizes one of these sequences being dialed. Then, the numbers following the prompt tone are matched against your standard dial plan, but the vertical service code is prepended by the PAP when it sends the invite to your * server. My thanks to sbradshaw for pointing this one out to me on the VT forum at BBR.