Something stuck? No Vpanel or inbound calls

**VOIPoTim** · 01-29-2009 02:49 PM

Has anyone else notice a drop this afternoon since I posted that it's fixed?

**KenH** · 01-29-2009 02:51 PM

Tim,

At this time, should we retain the test settings or revert to normal configuration?

Ken

**VOIPoTim** · 01-29-2009 02:54 PM

Originally Posted by KenH

Tim,

At this time, should we retain the test settings or revert to normal configuration?

Ken

Ken,

Right now to be honest it shouldn't matter. It appears the issue was completely unrelated.

**KenH** · 01-29-2009 03:06 PM

Returned HT502 to normal configuration. vPanel and HT502 CPL show both ports registered. I notice that now, NAT is shown as Symmetric, rather than Full Cone.
Incoming & outgoing calls are OK.

**buckethead** · 01-29-2009 03:26 PM

Update from me - I have not made any changes since the initial changes last night which did not involve making it unregistered and I am still up and working. No issues so I have not touched any settings today.

Forgot to add - vPanel has only shown one device registered the whole time. I do not have a 2nd phone hooked into FX2 so have not tested or anything there.

**dcshobby** · 01-29-2009 05:57 PM

Originally Posted by VOIPoTim

Ken,

Right now to be honest it shouldn't matter. It appears the issue was completely unrelated.

Can you start a brand new thread tonight with something to the tune of "Network Problems Fixed" so everyone can find it right away and maybe make it a sticky? Hope the problem is fixed for good and hope there was a good explanation for it too. Thanks!

**burris** · 01-29-2009 06:42 PM

Although all seems to be working well and I am still on Central02, the VPanel devices still show only one instance. Call records are up to date.

Since it is working, it really doesn't matter except to make you aware of it.
Maybe because line 2 still has a B after the number?

**quattrohead** · 01-29-2009 07:55 PM

I did not partake in any of this testing, but I do have the 502 registered 3 times in the CP !!!
502 is currently outside the router but I would like to move it back in sometime.

**Xponder1** · 01-29-2009 09:08 PM

Update 9:02 PM CST. Still setup with test configuration. Outbound calls using 7 digits on port 2 go to a busy signal again. Inbound calls work on both ports. Add the area code and the call goes threw. Have not tested a 800 number. Brandon had this fixed last night did something change?

I will reboot my ATA and try again in a little while.

**VOIPoTim** · 01-29-2009 09:10 PM

Originally Posted by Xponder1

Update 9:02 PM CST. Still setup with test configuration. Outbound calls using 7 digits on port 2 go to a busy signal again. Inbound calls work on both ports. Add the area code and the call goes threw. Have not tested a 800 number. Brandon had this fixed last night did something change?

I will reboot my ATA and try again in a little while.

Everyone should be able to revert to the normal configuration without issues now as well.