Something stuck? No Vpanel or inbound calls

[VOIPoTim]

Edit 09:43 EST:
vPanel now showing three devices, all with identical data (port numbers, expiration time, etc.)

Ken

This is good. I bet enabling Unregister on boot would take care of this. When it shows 3 lines, that's typically what it needed.

[KenH]

This is good. I bet enabling Unregister on boot would take care of this. When it shows 3 lines, that's typically what it needed.

Tim:

Didn't make any changes to configuration, rebooted, and vPanel only showing one device now. Should I change the Unregister on Reboot setting?

Ken

[fisamo]

Update::: Don't know if this is normal, but I reverted back, and everything works as it should, but I just looked up and the lights on Line 1 and Line 2 are both blinking together. It's been going on now for about 10 minutes. I made a call and received a call and it works fine, but the lights are blinking.... Anything related to this ongoing problem?

Is that what the device does during a f/w update? (Even if so, not sure why it would have gone on for so long...)

[scott2020]

I have 4 devices showing up in Vpanel right now. Things seem to be working fine, but I thought it was a little strange.

[Xponder1]

Update::: Don't know if this is normal, but I reverted back, and everything works as it should, but I just looked up and the lights on Line 1 and Line 2 are both blinking together. It's been going on now for about 10 minutes. I made a call and received a call and it works fine, but the lights are blinking.... Anything related to this ongoing problem?

Are you sure you do not have voice mail? That would make both lights blink.

[Vumes]

Are you sure you do not have voice mail? That would make both lights blink.

You learn something new everyday. I do indeed have voicemail. I deleted them and the lights went off. Sheesh. Thanks.

[KenH]

vPanel reverted to:

You do not currently have any devices registered to our servers!

[bretski]

Sorry I missed this thread last night, otherwise I would have gladly helped with the testing. FWIW, I'm running ok as of a few minutes ago, after having to reboot a couple of times yesterday...

[dswartz]

I've had the same IP/port showing as a registered device on more than one occasion, although it is now only one, and I've never noticed anything acting wrong or strange when it was more than one.

[scott2020]

Right now my ATA information page says "NOT REGISTERED" and I go directly to voicemail. I am running the test config.